Board is ready to go ....... in a few days.

Ethernet issue has been resolved, problem was from both HW and SW side.

Ethernet hardware is validated and good when the following 2 modifications are applied,
1: Connect the Ethernet ground to the ground plane via a 0805 ferrite bead.
2: Fix connection in the CT of the transformer.

Then newer driver from Ethernet chip manufacture was ported into both u-boot and kernel, board now flies!

Video pass-through relay was wrongly placed, this will be part of the HW mods too.

Both Remote Control and RTC are working now...

Board will be released once hardware mod is done and tested, a newer version BSP and application code will be released with it.